Battersea and Back Default Version - a Scenario Set for the London to Brighton route

This set contains a 3 part scenario. This version is believed to use only
default rolling stock and rolling stock provided as a part of the the
standard Railworks 2012 installation.

Install
=======

First obtain and install the route.

This scenario was designed with the "London to Brighton" route obtained from the
DLC Steam Store.

Install any or all:
BatBakDefP1.rwp
BatBakDefP2.rwp
BatBakDefP3.rwp

with RW3 Package Manager. Find it via the tab on the opening page.

This will install 3 standard scenarios to the London to Brighton Route
Battersea and Back P1 Default
Battersea and Back P2 Default
Battersea and Back P3 Default

Failure to run a scenario is almost always due to missing or improperly installed rail equipment.

------------------------------------------------------------------------------------------------------

IMPORTANT NOTE:

As with any complex scenario - SAVE OFTEN.

--------------------------------------------------------------------------------------------------------
NOTES: These scenario are essentially identical to the non-default versions, differing
only by the rolling stock and some minor AI traffic.

Special thanks to Dr. Richard Carter and Don Hughes for his beta testing of this scenario.

Your comments are welcome (actually desired) at jbfried@rochester.rr.com

Version History:
0.5 beta test version
1.0 original posting