Thanks for downloading my Milwaukee Road Rail Road repaints of the excellent EMD F3 A&B units from DTM, in the flamboyant black-orange paint scheme.
These two locomotives could easilly be found on the superb Pipestone Pass: Three Forks – Butte route.

There are two locos with dynamic numbers: A-unit (with or without a driver) and B-unit
    
These will fonction ONLY if you import the following 2 files from Assets\DTM\F3 UP\RailVehicles\Diesel\F3_Engine_CGW : F3_CGW_01.geopcdx and F3B_CGW_01.geopcdx.

Installation
------------
1- Open the zip archive, find the Assets folder, drag it to your Railworks folder. Answer "Yes" to the prompt about merging the Assets folder.
2- Copy from DTM\F3 UP\RailVehicles\Diesel\F3_Engine_CGW the following two 3d files : F3_CGW_01.geopcdx and F3B_CGW_01.geopcdx
3- Paste these two files in the new folder, i.e.: DTM\F3 UP\RailVehicles\Diesel\F3_Engine_MILW black-orange
4- Drill down to Assets\DTM\F3 UP\RailVehicles\Diesel\F3_Engine_MILW black-orange folder to check if all 7 files are installed, i.e.:
   . F3_MILW_black-orange_nd
   . F3_CGW_01 (geopcdx)
   . F3A_MILW_black-orange
   . F3A_MILW_Numbers
   . F3B MILW_black-orange
   . F3B_CGW_01 (geopcdx)
   . F3B_MILW_Numbers

To use in a scenario
--------------------
Launch the scenario editor and enable assets from DTM: F3 UP
After activation, you should see 3 Units: A-unit with or without a driver and a B-unit (all with dynamic numbers).
------------------------
Thanks to Chacal for uploading and managing the RWA Library.

Enjoy, Bernard
(QcRail) April 2025