Coupler Questions
Posted:
Wed May 16, 2012 11:12 pmby Shayfan1
I have a British payware car. Since it has buffers and the link and pin I swapped them for the buckeye couplers. However on one end the coupler is almost hidden the other is sticking way out. It is also too high. Is there a way to adjust this in the bin files. I have been looking but not having any luck.
Re: Coupler Questions
Posted:
Fri May 18, 2012 3:05 amby g_nash
Shayfan1 wrote:I have a British payware car. Since it has buffers and the link and pin I swapped them for the buckeye couplers. However on one end the coupler is almost hidden the other is sticking way out. It is also too high. Is there a way to adjust this in the bin files. I have been looking but not having any luck.
you will have to play with the bin , see here for info on the section that contains the matrix
http://forums.uktrainsim.com/viewtopic. ... view=print .
Re: Coupler Questions
Posted:
Fri May 18, 2012 12:16 pmby Shayfan1
Thanks for the link! I knew I had read about doing this but couldn't remember what site it was from. I guess I should have checked there first.