Railworks America

Hi all,

Just wondering if anyone else is experiencing this... when I go to load a scenario or go to the Croxton area of the Bergen Line I get an Out of Memory error. It only started happening within the past few months. Anybody else get the same issue?

Thanks,
Ken

It's OK here. Any particular scenario that's giving you a problem? I just did a QD here.

buzz456 wrote:It's OK here. Any particular scenario that's giving you a problem? I just did a QD here.

I have tried Quick Drive, scenarios, and even the route editor itself. Out of Memory on all tries.

I have plenty of horsepower on my Graphics card (RTX3050) and I have plenty of RAM (32GB) my graphics card is an i7 at 4.0Ghz. I used to be able to run the route just fine...

Should I delete the folder completely and let the file re-download?

Well....again...I answered my own question...

Leaving this here for anyone else...

Delete the folder and let the Sim re-download the route from the workshop... that seemed to fix the problem.

If I remember well, the Bergen County Line updates produced out of memory issues over previous installations. The solution was deleting (or backing up) the old route and installing the new one.