Railworks America

So has anyone seen this problem. Reppo Baldwin Centipede loads fine in QD and the standard scenario but I just tried to load it in a free roam and EEK! Anyone else have this issue and more did you figure out what to do to fix it?

The centipede comes in three parts, the front trucks, the rear trucks, and the body. Looks like the F&R trucks didn't load.

Harry

Any ideas how to fix this?

Are the front and rear trucks not loading even after you place them in the freedom scenario editor? Maybe create a consist in the QD consist menu, then in freeroam editor, click on the newly created consist.

Tried loading into Testtrak. same problem. Have you tried reaquiring the DLC?
edit
Testtrak add was done in 32 bit.
Interesting... re-downloading from steam made no difference. BUT... standard scenarios in Horseshoe Curve show complete engine. Also Previously made freeroams also show complete engine.

Yes I re-acquired. I really never played with this other than in some QD and standard scenarios until Harry asked about doing a re-paint so it might have been this way all along. I guess I'll go poke around in the bin file and see what it says.

I'll play with my model this afternoon too.

I loaded one of the career scenarios for the Baldwin Centipede on the HSC route. All is as it should be.

Harry

Mystery solved. In free roam the wheels are listed over in the cars not in the engine folder. It shows as Centipede Front wheels and Rear wheels. Seesh could he have made it any more obscure? I may change that after I do the repaint if I can get that done but at least now I can start trying to see what all is involved.

Unreal!!!

Technically, they are actually wagons.
It's obscure, but the Centipede manual does mention this.

Chacal wrote:Technically, they are actually wagons.
It's obscure, but the Centipede manual does mention this.

Manual? Manual? I don't need to read no stinking manual!